autodesk quantity takeoff lumber cut list

For seven-foot rear walls, you can get two seven feet studs from fourteen-foot studs instead of cutting a foot off from eight-foot studs. For instance, if you need 2×6 floor joists, you can buy 12-foot-long studs and cut them in half instead of 8-foot studs that will have a two-foot wastage per joist. You can ensure proper material usage by reducing wastage. Specifies a factor to accommodate for the contraction or shrinkage of the fill material.A good framing takeoff does not necessarily give you the best material use. Specifies the expansion or swell of the cut material. Specifies the default style used to display the material in a section view. For information about shape codes, see About Point, Link, and Shape Codes for Subassemblies. Calculates the volume of one or more corridor shapes (as defined by the shape codes that are used to define the corridor). Compares two surfaces to calculate both cut and fill areas and displays them separately.

Defines an area in the section where a material is removed and refilled with fill material. Specifies a corridor shape that is included in the structure type definition. Used with Base to define two or more surfaces for earthworks or cut and fill material types.

Specifies that this surface is the surface to compare against the base surface. Used with Compare to define two or more surfaces for earthworks or cut and fill material types.

Specifies that this surface is the surface to compare against the compare surface. Used with Above to define two or more surfaces for cut, fill, and structures material types. Specifies that an area below this surface is included in the material definition. Used with Below to define two or more surfaces for cut, fill, and structures material types. Specifies that an area above this surface is included in the material definition. Specifies the condition on which to base the calculation: Click next to the material name to display its components (surfaces). The properties table contains the following columns: Material Name Note: If a material is not selected, the data is not added.

Autodesk quantity takeoff lumber cut list